Good point, yes that is another variant.
Just curious, how did you configure the CBUS events? One for each position that is ON when it is exactly in position and all are OFF while moving?
Does it auto home on power on, or do you need to send an special aspect value to home it?
Does is also have a special aspect command for doing a 180deg rotation?
Wouldn’t it be easier to just use one input address per track + a moving. That is something we can more easily support in general. If we extend the YaMoRC DCCext protocol with a home aspect (e.g. 255) then you might be able to use it without custom Lua driver (all though that is still nice to add and test as well.)
Did a quick read of then YD7652 manual. The Märklin and Fleischmann protocols are explained to, so it shouldn’t be that hard to build drivers for those too.
That would make the turntable driver list (for now):
- Märklin
- Fleischmann
- YaMoRC DCCext
- EX-Turntable
- Custom/DIY/Lua (we need to name this properly)
There are more in the wild, we can always add them once someone requests it, then we have a test user as well 
@swinguk is there also a turntable control kit for CBUS? (If yes, is there any documentation available about the commands used to control it?)
A (not to expensive) turntable is on my need to buy list, but currently the financial priority is at the Demonstration and test layout project (which is quite expensive), part of the hardware is sponsored by companies, I’m very grateful for that.
Greetings,
Reinder